HW 200 (2SN)

Hot water hose

HW 200 (2SN) HW 200 (2SN)

Properties

Application area
High pressure cleaning equipment
Standard
EN 853 2SN
Inner layer
water, oil and heat resistant synthetic rubber
Insert
two high tensile steel wire braided inserts
Outer layer
environmentally safe synthetic rubber
Colour
black
Temp. min.
-10 °C
Temp. max.
150 °C
Elongation
+ 2 % to - 4 %
Media
Water
Mineral oil (up to + 100°C)
Water-oil emulsions

Note

The change in length of the hose is determined at max. working pressure during testing to EN ISO 1402.

Item

4 Item
Identification DN* Size Inches Internal Ø nom.
mm
External Ø nom.
mm
Operating pressure
bar
Burst pressure
bar
Min. bending radius
mm
HW 206 6 4 1/4" 6.4 15.0 400 1840 100
HW 208 8 5 5/16" 7.9 16.6 400 1470 115
HW 210 10 6 3/8" 9.5 19.0 400 1320 130
HW 213 12 8 1/2" 12.7 22.2 400 1200 180
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.

All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.